Robotronics Buzz E Instructions d'exploitation télécharger pdf (Page 20)

Voice System

How to Operate the Receiver (in Robot)

There are two adjustments on the receiver. The volume is on the back of the receiver, which

you may set to the desired volume. On the UHF UB-10 you can change the volume on your belt

transmitter on the fly. The other adjustment is the sensitivity. This is factory preset to

maximum sensitivity. This effects how sensitive the receiver is to the transmitter signal.

Typically you would never need to adjust this. The only exception would be if you get squelch

when the transmitter is off. You can deal with this by simply turning on the belt transmitter

whenever the robot is turned on. You could turn the sensitivity down slightly but turn the

adjustment as little as possible, because adjusting it will affect the range.

Function of the LEDs

TX LED- This indicates that you are receiving a signal from the transmitter. On some units it is

a single TX light. On other units it may have an A or B that it will alternate between.

AF LED- This light indicates that audio is going through the receiver. It will flash as you speak

into your headset mic.

Tip: For best range extend the receiver antenna(s) as much as possible, not allowing it

to touch metal.

1. Power On LED Indicator

2. Diversity LED Indicators

3. AF Peak LED Indicator

4. Antennas

5. Power Switch (Leave On)

6. DC Input Jack

7. Frequency Label

8. Squelch Control

9. Aux. Volume Control

10. Audio Output

11 Balanced Mic Audio Output XLR

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 60 61

Pas de commentaire

Robotronics Buzz E Instructions d'exploitation Page 20