Robotronics Buzz E Instructions d'exploitation télécharger pdf (Page 13)

Chapter 4 The House with Lights

The House lighting system is made up of two main light types; the room panel lights and the

LED lights. The LED lights are used for the smoke alarms in each room and to indicate the

hazards. The room lights have a switch and the LEDs in a room has a switch.

When you hit a switch on the control panel, this input is picked up by the control panel main

board and sent along the wire to the main board in the House. This signals the correct

switching output to turn on the room light or hazard LED. There are connectors going from

each light to the switching outputs.

How to remove the front panel in order to change a color panel, room bulb, or hazard LED:

1. To do this, find the dowel velcroed on the back of the house. Insert the dowel into the hole

in the back cover of the house. Push on the dowel and this will flex out on the front panel(s)

so that you can get your hand behind it. Next, slide the top of the panel down to release it

from the top slots.

2. The other way is to remove the back cover of the house, push down the tabs of the front

panel, and flex out the panel. Look up in the back of the house and you will see these tabs.

Push down on them and the panel will flex on the front. While you are pushing down, have

someone in the front pull out the flexed panel at the top.

Room Light Bulb

Hazard LEDs

Changing to a different color panel:

After releasing the top of the clear panel, open it enough to get the color panel out and slide the

new color panel in. Flex the clear panel enough to pop the tabs back up into the slots.

Chapter 4 The House with Lights

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 74 75

Pas de commentaire

Robotronics Buzz E Instructions d'exploitation Page 13